Cannot do a sensor analysis on Mallincam DS10c TEC
Posted: Sat May 23, 2020 7:37 pm
Hello Robin et al>
I have a Mallincamsky DS10c TEC camera which has a Sony IMX294 sensor. These are used in ZWO's camera of that same name. However when I did an attempt at sensor analysis I got the following message:
See attachment
Now is there a way around this roadblock? 1) Can I not use the ZWO camera model that uses the same sensor? 2) Can I disable Direct Show?
Dan Kahraman
I have a Mallincamsky DS10c TEC camera which has a Sony IMX294 sensor. These are used in ZWO's camera of that same name. However when I did an attempt at sensor analysis I got the following message:
See attachment
Now is there a way around this roadblock? 1) Can I not use the ZWO camera model that uses the same sensor? 2) Can I disable Direct Show?
Dan Kahraman