Page 1 of 1

Conesharp Questions

Posted: Thu Oct 11, 2018 8:20 pm
by cuivenion
I assume that when using Conesharp I at no point use any syncs. Also, when centering each star, do I use the eqmod controls? Or do I undo the clutches and center manually. Apart from the final step of course, where I'm centering using the dovetail bolts to remove the error.

Re: Conesharp Questions

Posted: Sat Oct 13, 2018 9:40 pm
by admin

it should all be done with EQMOD controls. There are no syncs and in fact you must disable any multipoint sync mapping in EQMOD otherwise that will hide the very error that ConeSharp is trying to measure.



Re: Conesharp Questions

Posted: Sun Oct 14, 2018 12:51 am
by cuivenion
Thanks, just need a clear sky now.