Make sure that your filters are compatible with your filter wheel

Somewhere to share your expertise in using SharpCap
Post Reply
User avatar
oopfan
Posts: 456
Joined: Sat Jul 08, 2017 2:37 pm
Location: New York
Contact:

Make sure that your filters are compatible with your filter wheel

Post by oopfan » Sat Oct 20, 2018 4:05 am

After having purchased my first monochrome camera 10 months ago I have gone on a shopping spree buying filters. In total I have four Optolong LRGB filters, two Astrodon Photometric filters, three Orion narrowband filters, and one Orion dark filter. I began with an Orion 5-position manual filter wheel but soon I became interested in automation so I purchased a ZWO MiniEFW.

I really liked the finish of the MiniEFW and that it was light-tight, the Orion FW not so much. I loaded the EFW with my Optolong LRGB filters and the Orion dark filter. It worked great for many months until yesterday when I decided to swap out the LRGB filters for my Orion narrowband filters. I discovered quite unexpectedly at the telescope that the wheel would not turn. I scrambled to move the narrowband filters back into the manual wheel so I could continue imaging.

So here is the problem. The MiniEFW requires that the thickness of the filter cell, minus the threads, be less than 7mm. Unfortunately all of my Orion filters and Astrodon filters are 7.5mm. Only the Optolong filters meet the requirement at 5.5mm. For the astute reader you might of caught that I reported a fully functional wheel having four 5.5mm filters and one 7.5mm filter. The best I can figure is that the stepper motor could overcome the drag from that one 7.5mm filter but not four of them last night.

Anyhow, I thought this might be helpful for those of you like me who like to "mix and match" -- beware!

Brian

User avatar
admin
Site Admin
Posts: 3094
Joined: Sat Feb 11, 2017 3:52 pm
Location: Vale of the White Horse, UK
Contact:

Re: Make sure that your filters are compatible with your filter wheel

Post by admin » Sat Oct 20, 2018 1:33 pm

Hi Brian,

it's a shame when this sort of thing happens. I remember when I was testing a prototype of the Xagyl USB filter wheel, the manufacturers asked me to measure all the filters I had to find out the height that needed to be available to ensure clearance :)

cheers,

Robin

User avatar
oopfan
Posts: 456
Joined: Sat Jul 08, 2017 2:37 pm
Location: New York
Contact:

Re: Make sure that your filters are compatible with your filter wheel

Post by oopfan » Sat Oct 20, 2018 2:11 pm

Hi Robin,

It's quite frustrating that there isn't greater effort to agree on labeling standards among astronomy equipment manufacturers. I dabble in electronics and have always been impressed with the attention to detail in manufacturers' datasheets. It's as if they want you to buy their products. Granted the electronics industry is much larger than the astronomy industry so maybe they have money to burn on good documentation. Sadly, astronomy retailers don't pick up the slack. They simply copy the specs that the manufacturers publish. Would you believe I had to dig down into the Q&A section of the ZWO site in order to find the 7mm clearance limit for the MiniEFW? And with regards to filter cell height, I can't find a thing.

Brian

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest