Auto flip for meridian change

Got an idea for something that SharpCap should do? Share it here.
Forum rules
'+1' posts are welcome in this area of the forums to indicate your support for a particular feature suggestion. Suggestions that get the most +1's will be seriously considered for inclusion in future versions of SharpCap.
Post Reply
calan
Posts: 90
Joined: Mon Feb 13, 2017 7:37 am

Auto flip for meridian change

#1

Post by calan »

When changing sides of the meridian, the captured and stacked image is flipped horizontally and vertically, requiring new flats and darks. Add a "meridian flip" check box to the main stacking tab, which automatically flips any associated darks and flats to match the "flip" setting.

There are a few ways this could work. One idea (probably the simplest to implement and easiest to use) would be to assume that darks and flats are always captured with Flip = None. Then when Flip is changed, SC would manipulate any loaded darks and flats based on that to match.

One possible workflow:

1. Pause stacking
2. Do a meridian flip and reaquire target.
3. Change the Flip parameter so that image is re-aligned with current stack. When SC sees that the flip value has changed and that there is a dark and/or flat being used, it automatically adjusts the dark and flat to work with the flipped image.
4. Fine tune position of target if needed
5. Resume stacking

A bit nicer approach would be for SC to "make a note" of the Flip parameter when the camera profile is first loaded, and use that as the baseline to calculate the adjustments from. That would allow any flip value to be set in a profile, rather than relying on an assumed "none" value.
astrnmr
Posts: 44
Joined: Fri Jun 16, 2017 1:11 am

Re: Auto flip for meridian change

#2

Post by astrnmr »

This would be an impressive feat added to SC.
Post Reply