Page 1 of 1

Scope Settings Feature

Posted: Sun Mar 03, 2019 4:48 pm
by jsawaski
Would it be possible to have a "Reverse" check box for both left/right and up/down directions for the mount control? This way I could set the direction for moving the scope to make more sense to me.

I run different configurations and always seam to move the wrong way at the worst time. If I could set the direction how I want them at the start it would be great.

I got this idea because you have a "Reverse" for the focuser.

Re: Scope Settings Feature

Posted: Wed Mar 06, 2019 12:58 am
by roelb
Use "Horizontal/Vertical Flip" settings?

Re: Scope Settings Feature

Posted: Fri Mar 08, 2019 10:20 pm
by jsawaski
That requires a new dark and flat for each combination of flip. Changing the arrow directions does not compromise calibration frames.

Re: Scope Settings Feature

Posted: Sat Mar 16, 2019 3:53 am
by jsawaski
Admin has never replied or commented on this.

Re: Scope Settings Feature

Posted: Sat Mar 16, 2019 2:54 pm
by BlackWikkett
Can't answer for Robin but the way I get around this, so I don't totally wreck my framing. I Set the slew rates to very low. In the case of my CEM60 2x. Since the slew rate is so low it's very easy to go back if the current orientation isn't moving the mount in the direction I intended.